Instructions: Wooden Nativity Block Set

Items Needed:

• 6 Wooden Blocks
• Sandpaper
• Nativity Pictures Printout (you can access the document HERE.  There are two sets to a page.  Pictures courtesy of http://preparednotscared.blogspot.com)
• Other Paper, cut into 1 1/4 inch squares, if desired (not included)
• Scissors (not included)
• Corner Rounder, optional (not included)
• Mod Podge (not included)
• Paintbrush (not included)

STEP 1: Sand any rough edges of wooden blocks with sandpaper.

STEP 2: Cut out nativity pictures, using the grid printed on the paper as a guideline.  If desired, also cut out other paper to cover sides not covered by a nativity picture.

STEP 3 (optional):  Using corner rounder punch, round all the corners of paper/nativity pictures, if desired.

STEP 4: Using a small amount of mod podge, paint a little bit onto a side of the wood block then adhere picture/paper to it and go over the whole side of the block with mod podge as well being careful not to move the paper/picture as you brush it on.

STEP 5: Continue until all sides are covered (make sure you leave a side that is not drying, so you can set it on the table!)

STEP 6: Let dry.

Enjoy your Nativity Block Set!